When connecting an RS485 module to a 2 wire Belden 9841 for a Modbus network to read electric meters, should the wiring configuration be a ring or radial setup? Your guidance is appreciated. Thank you.
An open-ended ring with terminating resistors at each end.
In my experience, for a Modbus network, your wiring configuration should ideally be a daisy chain or a linear bus topology. Avoid the ring setup as Modbus isn't designed to handle it, and a radial setup might lead to reflections. Belden 9841 should work fine with your RS485 module. However, make sure your termination resistors are correctly placed at each end of the bus to match impedance and reduce noise.
✅ Work Order Management
✅ Asset Tracking
✅ Preventive Maintenance
✅ Inspection Report
We have received your information. We will share Schedule Demo details on your Mail Id.
Answer: 1. What is the recommended wiring configuration for connecting an RS485 module to a Belden 9841 cable for a Modbus network with Schneider Electric meters? - The recommended wiring configuration can be either a ring or radial setup, depending on the specific requirements of your system.
Answer: - The choice between a ring and radial setup can affect factors such as signal integrity, reliability, and ease of troubleshooting within the Modbus network.
Answer: - It is important to consider factors such as network topology, distance between devices, potential for signal interference, and overall system requirements when selecting the wiring configuration.
Answer: - Advantages of a ring setup may include improved fault tolerance and redundancy, while a radial setup may offer simpler installation and maintenance. However, the specific benefits will vary based on the project requirements.
Join hundreds of satisfied customers who have transformed their maintenance processes.
Sign up today and start optimizing your workflow.