Greetings all, I am in the process of configuring a Siemens DC drive, the model 6RA8018-6DV62-0AA0, to communicate with Siemens' Starter software. I am seeking guidance from anyone who has experience with this particular drive. Can it be accessed through Ethernet or RS-232? If affirmative, what specific parameters and configurations are needed for establishing this link? Your support and insights are greatly appreciated in advance. Thank you.
For information on the STARTER software, refer to page 273 of the manual for the DC Converter from Siemens. Additionally, page 298 covers details on the serial interface.
Hello, I've worked with that Siemens model before. Yes, it can communicate via both Ethernet and RS-232. For Ethernet, you'll need to assign an IP address to the drive first. From there, you can use the Starter software to communicate. RS-232 will require a connection from your device to the port on the drive and you'll need to configure the port settings correctly as per drive manual. The specifics can be a bit tricky so I would certainly recommend studying the manual, particularly the sections on commissioning and drive communications. Best of luck with your configuration process!
Hi there! The Siemens DC drive you're working with does support communication via Ethernet and RS-232. However, I've found Ethernet communication to be more reliable with the 6RA8018-6DV62-0AA0 model. You'll need to set the IP address, subnet mask and gateway of the drive using the Starter software. Then, make sure your software and the drive are on the same network. If you are going for RS-232 connection, the configuration settings like baud rate, data bits, parity, etc. should match on both sides. A little word of caution - always ensure to power down the drive before making Ethernet connections; it helps prevent any short-circuits or accidental damage. Best of luck with your setup!
Hi there! Yes, the Siemens 6RA8018 drive can communicate via both Ethernet and RS-232, but Ethernet is generally preferred for its speed and efficiency. To set it up, make sure you configure the drive's communication settings in the Starter software to match your network parameters, including IP address, subnet mask, and gateway for Ethernet. For RS-232, you'll need to adjust the baud rate and ensure the correct communication cables are connected. Double-check the manuals for any specific parameters related to your software version, as they can have different requirements. Good luck with your setup!
✅ Work Order Management
✅ Asset Tracking
✅ Preventive Maintenance
✅ Inspection Report
We have received your information. We will share Schedule Demo details on your Mail Id.
Answer: - Yes, the Siemens DC drive model 6RA8018-6DV62-0AA0 can be accessed through either Ethernet or RS-232 for communication with Siemens' Starter software.
Answer: - To establish a communication link between the Siemens DC drive model 6RA8018-6DV62-0AA0 and Siemens' Starter software, specific parameters and configurations need to be set up in the software, such as the IP address for Ethernet communication or baud rate for RS-232 communication.
Answer: - For successful communication between the Siemens DC drive model 6RA8018-6DV62-0AA0 and Siemens' Starter software, it is recommended to double-check the network settings, ensure the correct communication protocol is selected, and verify the cable connections for Ethernet or RS-232 communication.
Join hundreds of satisfied customers who have transformed their maintenance processes.
Sign up today and start optimizing your workflow.