Hello! I successfully retrieved a string from ControlLogix and displayed it on PanelView 800. However, I am now facing a challenge in reverse - inputting a string on PanelView 800 and reading it on ControlLogix. Has anyone attempted this process before? Let me know your experiences and solutions!
To establish communication between a string input object and a Programmable Logic Controller (PLC), simply create the object and specify the tag on the PLC where you want the data to be written. This allows for seamless integration and data transfer between the two systems.
Hey there! I've actually had a similar experience in the past. It might be a bit tricky initially but communication between PanelView 800 and ControlLogix is quite possible. You'll have to set up a String Input object on the PanelView first, then in the ControlLogix, you read the string as an array of SINTs. You can then reconstruct your literal string from these SINTs. I'll suggest you refer to Rockwell's documentation for a more detailed step-by-step process. It was a lifesaver for me!
Hi there! In my experience with PanelView 800 and ControlLogix, the key is to ensure you're inputting the string in the right format and defining it correctly within ControlLogix. The 'string' data type in ControlLogix uses a structure that includes .LEN and .DATA, with .LEN being the length of the string. Make sure your setup accommodates this structure. Work with STRING DEFINITIONS in ControlLogix and, on the PanelView side, remember to configure your string input object properly. Hope this insight helps!
Hey there! I've encountered the same challenge in my operation. The trick I found was to use global connections, which work both ways. Instead of inputting directly on the PanelView 800, I created a new string tag in the PLC and mapped the PanelView string input to it using global connections. Now, whatever is entered on the PanelView 800 is directly read on ControlLogix through the created string tag. Hope this helps and good luck with your operations!
✅ Work Order Management
✅ Asset Tracking
✅ Preventive Maintenance
✅ Inspection Report
We have received your information. We will share Schedule Demo details on your Mail Id.
Answer: 1. How can I input a string on PanelView 800 and retrieve it on ControlLogix? - To input a string on PanelView 800 and retrieve it on ControlLogix, you can use communication protocols such as Ethernet/IP or Modbus TCP. Ensure that the PanelView 800 sends the entered string data to the ControlLogix PLC over the established communication network.
Answer: - Firstly, configure the communication settings on both the PanelView 800 and ControlLogix PLC. Then, design the PanelView 800 interface for string input. Next, establish the data exchange mechanism using appropriate communication protocols. Finally, program the ControlLogix PLC to receive and process the incoming string data.
Answer: - Ensure that the PanelView 800 and ControlLogix PLC are properly configured to communicate with each other. Check for any network issues or protocol compatibility issues. Verify that the string data format is consistent and correctly interpreted on both devices. If facing challenges, consult the user manuals or technical support for assistance.
Join hundreds of satisfied customers who have transformed their maintenance processes.
Sign up today and start optimizing your workflow.